Filling the bear dark fur sections.
9. I enlarged the bears to 300% because it is hard to get
the Magic Wand in all of the smaller parts where you want
the fur on his face. You can close out the knit .ufo and any
others you still have open. You only need the bears to be
open to work on now.
The screen shot below will show you the settings I used for
the Magic Wand on the bears face. Use the magic wand and
click the areas of the face. If you happen to hit the black
outline you can click on the redo button.
When you finish the face area Rc/Expand/Shrink and expand
1
pixel, click ok.
Rc Convert to Object. To fill the bear go to Edit/Fill and
looking at the ss below get the fur fill and fill the bears
face with it.
Click ok in the fill box and your bear will look like this
one below.
Now he's starting to get cute! Do the other bears face next. All of the dark bear
body parts
need to be filled exactly the same way just repeat
the above instructions. Go ahead and finish the dark fur
part on both of the bears. Look at the 3rd ss below so you can
see which ones to do. Please don't forget to Save after
each part you finish!
Note: If you miss a small area and it leaves a white
spot don't worry about it we will fix it in the next step
just continue on until you get all the dark pieces finished.
Bear Parts to finish in dark brown ss below.
Cloning
10. Now we will fix the tiny spots we missed, if you
don't have any well done! You can skip this part.
As you see in my ss below I made the background green so
it is easier to see all of the spots.
Select the Clone paint brush with the settings shown
[enlarge if you need to see better]
Put the clone brush over the leg area Hold the Shift
key down to select that leg area you will see a blinking
white cross hair
[make sure you are in mode to clone paint] and paint
over the top of where ever you need to on the bear. You
will probably have different areas you missed than I
do....move to screen shot 2nd one below. I took my ss
before I clicked on in mode and it is at 100%.
Below you can see the white cross hair where you
selected the area on the leg. It also shows where I
cloned in my spots, just click and go to the next spot
and click again ...until you've got them all. Don't
forget the face areas and you don't have to worry about
cloning over top of the outline area. It won't show when
you're done.
When you click out of mode you will see all the spots
you made floating above the bear.
Rc and Arrange/send to back. If you have any area in the
blue knitted section then do it also.
Select over the blue scarf and click the shift key, to
select the spot, then
again paint in mode any area of the blue you may have
missed. Send the cloned pieces to the back.
Deselect by clicking your enter key.
*Change the background back to white*
Save
When you're finished fixing your missed spots ...;0)
Continue on to
page
4
pg 1
pg 2 pg
3
pg 4
pg 5
some results-pg6
